top of page

Installation Instructions

Installing the removable odor trap adapter (RSA)

scent lock right wrong

An odor trap adapter is an important part of a drainage system. It prevents unpleasant odors from rising from the drain. It is therefore important that the odor lock adapter is placed correctly and is replaced properly after cleaning. After replacing the scent lock adapter, always check whether it has been placed back correctly. This prevents the adapter from remaining open and unpleasant odors from escaping. Be careful when doing this so that the membrane is not lost.

Placement of the removable
water lock

It is important to check and clean the water seal regularly. This way the device continues to function properly and continues to do its job well. By correctly installing and maintaining the water trap, you can easily prevent unpleasant odors in your home.

water lock right wrong

Installation of ABS pit/gutter without sand skin

Lubricate the well or gutter with

adhesive primer or PVC glue.

sandy

Immediately sand the pit or gutter with sharp sand after filling.

2

After drying for 24 hours, the pit or gutter is ready for installation.

3

Installation of stainless steel pit/gutter without sand skin

Paint the well or gutter with red lead or primer.

stainless steel sanded 1

Immediately sand the pit or gutter with sharp sand after painting.

2

After drying for 24 hours, the pit or gutter is ready for installation.

3

Warning!

 

If you use a tile cleaning agent or the like, immediately rinse the drain or gutter thoroughly so that no aggressive residues are left behind.

warning
youtube

Installation instructions for drains and gutters that are already provided with a sand skin.

1

Ensure there is sufficient space to properly place the drain or gutter.

5
2

Sand and bevel the drain pipe.

6
3

Leg de afvoerbuis op het juiste afschot en hoogte om direct aan te kunnen sluiten. 

7
4

Before gluing, check the drain pipe again and mark it with a pencil so that the pipe is in the right place after gluing.

8

Glue the drain pipe.

Immediately check whether the drain or gutter is properly placed. Level the gutter or drain.

Connect grounding to the grounding point.

Apply firmly with cement mortar 1:3

1 part cement

3 parts sand

9
10
11
12

Level the well or gutter.

Werk vervolgens de vloer af. Droogtijd 24 uur. 

Placing tiles, the slope towards the pit is very important.

13

Drying time 24 hours.

14

Carefully grout the tile floor.

15

Voor een waterdichte overgang van vloer naar afvoerput of goot, het geheel afkitten met een polymeerkit.

16

After 48 hours of drying, the shower area is ready for use.

bottom of page